With the continuous development of society and the improvement of glass printing technology in our country, glass screen printers have more and more opportunities to enter the market. Good maintenance and maintenance of glass screen printer can reduce the failure of glass screen printer, improve the utilization rate of equipment and create higher economic benefits. On the contrary, high failure rate will lead to increased maintenance cost and use cost, shortened service life of machine, reduced investment value, but also increase shutdown rate and affect production. Then how to maintain the glass screen printing machine? The staff of Shenzhen Yibaolai factory will introduce to you below:

1. The operation of glass screen printing machine requires special operators, and the use of operating equipment needs training. Only after qualified training, can the operation of mechanical equipment be ensured to protect the mechanical equipment from damage.

2. Ink control in glass screen printing machine. In the process of printing, it is necessary to control the speed of inking, screen printing machine to ensure that ink can be uniform.

3. Check the oil quantity of oil cup in the converter of glass screen printing machine every day. The pressure relief valve should not be pushed on the back end for a long time. If conditions permit, it is better to install a freeze dryer.

4. Screen Printing of Glass Screen Printer, Control of Printing Rate. Screen printing speed can be controlled artificially. For an automatic screen printing machine, it can be set by itself without too many people to operate.

5. Clean the printed matter when printing with glass screen printer. The printing effect of screen printing machine is not only related to equipment, but also to printed matter. If there is water or dirt in the printed matter, it will cause the situation of no ink, which will affect the printing. Therefore, before printing, we should do a good job of cleaning the printed matter.

6. If the cylinder of glass screen printing machine moves too fast, rotating the flow control valve clockwise in this direction will slow down its speed, otherwise, if the action is too slow.

7. When printing glass screen printing machine, excessive moisture and oil can not be brought into the pneumatic system to avoid cylinder failure and shorten the service life of the cylinder, so as to ensure the dryness and cleanliness of compressed air.

8. The cross slide seat of the glass screen printing machine and the components with high precision must be cleaned and oiled regularly in order to prevent the precision from being affected by rust.

9. When entering compressed air, do not place any part of the body in a position where the screen printer can move, so as to avoid crushing.

10. When the glass screen printer stops working, the main switch of the power supply and the compressed air source should be turned off; the cylinder of the governor valve and the axis of each part should be avoided magnetic loss.