1. When printing on glass screen printing machine, it is not allowed to enter too much water and oil into the air pressure system to avoid cylinder failure and shorten cylinder service life, and to ensure the drying and cleaning of compressed air;

2, check the amount of oil in the converter of the glass screen printing machine every day is sufficient, the pressure relief valve should not be pushed to the back end for a long time, if necessary, it is better to install a freeze dryer;

3. When the glass screen printing machine stops working, the main power switch and compressed air source should be turned off; the speed control valve cylinder and the axis of each part should avoid magnetic loss;

4. The components of the horizontal sliding seat of the glass screen printing machine and the precision height matching components must be wiped clean and oiled frequently to prevent the precision from being affected by rust.

5. When the glass screen printing machine performs printing, the ink is controlled. When printing, it is necessary to control the ink discharge speed, and the screen printer should ensure that the ink can be uniform.

6. Glass screen printing machine screen printing, printing rate control. The screen printing speed can be artificially controlled. For a fully automatic screen printing machine, it can be set by itself and does not require too many people to operate.

7. When the glass screen printing machine is printed, the printing parts are cleaned. Screen printing machine, the printing effect is good or bad, in addition to the equipment, it is also related to the printing parts. If there is water or dirt in the printing parts, it will cause the ink to go up, affecting the printing, so the printed items Before that, be sure to clean the printed parts.

8. The operation of the glass screen printing machine requires a special operator. The use of the operating equipment requires training. After the training is passed, the mechanical equipment can be operated to ensure that the mechanical equipment is not damaged.

9. When introducing compressed air, do not place any part of the body in the position where the screen printing machine can move to avoid crushing.

10. If the cylinder of the glass screen printing machine moves too fast, rotating the flow control valve in the direction of motion in a clockwise direction slows down its speed. If the movement is too slow, the reverse is true.